Porcelain patios in Tamworth

How we lay porcelain

1. Choose. Pick the colour, size and finish.
2. Prepare. Dig out and lay a compacted base.
3. Prime. Apply slurry primer to each slab.
4. Lay. Bed on full mortar to a fall, joints even.
5. Joint. Fill joints with compound.
6. Finish. Clean down and hand over.

Laying out and bonding porcelain

We set out a Tamworth porcelain patio from a reference line, checking where the slab pattern meets thresholds and drainage channels. After preparing the supporting base and falls, we dry check critical cuts before bedding the paving. A compatible bonding slurry coats each porcelain underside immediately before it meets the mortar, following the product instructions. Spacers help maintain the specified joints, with movement provision considered at fixed structures. Jointing follows when the bedding is ready, with residue removed as directed.

Picking porcelain formats and finishes

Choose porcelain manufactured for exterior paving, checking its wet slip performance and installation requirements. Large slabs reduce the number of visible joints but need careful setting out around small corners and inspection covers. Compare pale, dark and stone effect samples in your garden light, including how the texture looks when wet. Matching grout should suit both the porcelain specification and the intended joint width, rather than simply copying an indoor floor finish.

Cleaning porcelain without damaging joints

Use a soft broom to remove grit from porcelain before washing with a suitable cleaner and rinsing away residue. Avoid abrasive tools or concentrated jets aimed along the patio joints. Check the grout manufacturer's guidance before treating stubborn marks, and keep drainage channels clear beside porcelain thresholds. Protect slabs when moving heavy planters and inspect chipped edges promptly, especially where paving meets a step or narrow garden passage.